Calf laying on straw
Updated: September 24, 2021
By Sarah Potts

Milk Replacer: Are your calves getting enough?

Milk replacer was historically developed in order to spare salable milk. However, milk replacer is now valued for its ability to provide a convenient, safe, consistent, and cost-effective source of nutrients for pre-weaned calves so long as proper mixing and feeding protocols are followed.

FOCAL POINT

  • Calves should double their birth weight by weaning to optimize production later
     
  • The amount of milk replacer required will vary depending on the calf’s size and growth rate as well as the energy and protein content of the milk replacer
     
  • Calves must consume more of a less nutrient-dense milk replacer to achieve results similar to those achieved with a higher density replacer
     
    • This may or may not be more economical in the long-run
       

 

Current Milk Replacer Feeding Practices

In the United States, approximately half of all dairy farms feed milk replacer (USDA APHIS, 2014). The proportion of herds that feed milk replacer is greatest for herds that milk between 100 and 499 cows (64%) and for those that milk between 30 and 99 cows (50%). Most farms feed between 4 and 5 quarts of milk or milk replacer on a twice daily feeding schedule and those that feed replacer feed one that contains 20% fat and 20% protein (see Table 1 on page 6).

In the world of calf nutrition, recent attention has been given to the long-term impacts of pre-weaning growth and nutrition on future production. Many of these studies indicate a significant relationship between pre-weaning growth and/or nutrient intake and first lactation milk production. One study indicated that a 0.1 pound increase in daily gain during the pre-weaning period was associated with a 105-pound increase in milk yield during the first 150 days of first lactation. Despite this, data presented in Table 1 indicate that many calves fed milk replacer are probably not receiving enough energy and protein to reach their full productive potential.

“increasing the feeding rate or nutrient density of a milk replacer is a significant economic investment, so it is important to weigh the cost vs. potential return...“

Feeding whole milk is the alternative to feeding milk replacer to pre-weaned calves, but substantial challenges related to nutrient consistency, pathogen exposure, and feeding logistics prevent its adoption on many dairies. Calves often appear to grow better when fed whole milk as compared to milk replacer and this is probably due to the greater fat (31%) and protein (25%) content of whole milk relative to commonly fed milk replacers (Table 1). However, milk replacer-fed calves can perform just as well as calves fed whole milk as long as they consume a sufficient amount of energy and protein by increasing milk replacer quantity, nutrient content, or both.

TABLE 1. DAIRY CALF MILK AND MILK REPLACER FEEDING PRACTICES BY HERD SIZE.
  % of Operations by Herd Sze
  Very Small
(<30)
Small
(30 to 99)
Medium
(100 to 499)
Large
(>500)
All Herds
FREQUENCY OF FEEDING
2 times per day 92 97 94 84 95
3 times per day 3 2 3 9 3
AMOUNT FED DAILY
4 to 5 quarts 56 55 54 35 53
6 to 7 quarts 17 22 21 25 21
more than 7 quarts  22 21 22 37 22
MILK REPLACER PROTEIN %
20% 47 61 59 52 59
21 TO 24% 26 31 32 26 31
Over 24% 18 9 9 23 10
MILK REPLACER FAT CONTENT
20% 72 82 87 65 82
21 to 24% 10 10 7 16 10
Over 24% 19 3 1 2 3
Data adapted from the 2014 Dairy Cattle Management Practices in the United States published by USDA APHIS NAHMS (https://www.aphis.usda.gov/animal_health/nahms/dairy/downloads/dairy14/Dairy14_dr_PartI_1.pdf

(Re) Defining Your Goals

When asking yourself whether or not your calves are getting “enough” nutrition from milk replacer, you first need to ask yourself (and be honest) whether your calves and first lactation cows are performing the way you think they should be. If the answer is no, then you should look at several aspects of the heifer program to determine where improvements can be made. Measurements such as birthweight, weaning weight, morbidity and mortality rates, age and weight at breeding, and age and weight at first calving are critical pieces of information for this assessment. For the pre-weaned calf program, weaning weight is an invaluable measurement that can be helpful to pinpoint potential shortcomings of the milk feeding program. The Dairy Calf and Heifer Association recommends that calves double their birth weight by weaning. With this in mind, a 90-pound calf would need to gain roughly 1.6 pounds per day in order to double her birth weight by 56 days (8 weeks). Typical target growth rates for pre-weaned calves range from 1.2 to 1.8 pounds per day, through rates greater than 2 pounds per day are generally not advised due to potential long-term negative effects on milk production.

Determine How Much to Feed

The amount of milk replacer that should be fed is a function of the calf’s body weight, target growth rate, and the fat and protein content of the replacer itself. The dairy cattle NRC (2001) has a set of equations that can be used to estimate a calf’s daily energy and protein requirement.

Based on these estimated requirements, feeding 5 quarts of a 20:20 milk replacer (at 12.5% solids) is simply insufficient to achieve a growth rate that would enable the average calf to double her birth weight by 8 weeks of age (see Table 2 below). As shown in Table 2, this feeding rate provides the calf with only about 65% of the energy and 48% of the protein she needs. Feeding at this rate will likely limit growth to about 0.7 pounds per day, especially before measurable amounts of starter grain are consumed. Even feeding a 22:20 milk replacer at 5 quarts per day is insufficient, and growth will still be limited to about 0.8 pounds per day.

TABLE 2. DAILY MILK REPLACER FEEDING EXAMPLE 1: A 90-LB CALF WITH AN ADG OF 1.6 LB/D FED A 20:20 MILK REPLACER¹
Powder
(lb)²
Water
(Quarts)
Amount Fed
(Quarts)
Energy
(% or Req.)
Protein
(% of Req.)
1.0 3.5 4.0 52 39
1.6 5.25 6.0 78 58
2.1 7.0 8.0 104 76
2.6 8.75 10.0 130 95
¹Calculations are based on equations from the 2001 Dairy NRC. It is assumed that the milk replacer contains milk-based proteins and has a lactose content of 45% (DM-basis).
²Powder: water ratio presented ensures a mixed solids content of 12.5%

So, what can be done to increase pre-weaning gain? There are three options: increase the nutrient density of the milk replacer, increase the amount of milk replacer fed, or a combination of both. Table 3 shows an example of the same 90-lb calf fed a 27:20 milk replacer.

TABLE 3. DAILY MILK REPLACER FEEDING EXAMPLE 1: A 90-LB CALF WITH AN ADG OF 1.6 LB/D FED A 27:20 MILK REPLACER¹
Powder
(lb)²
Water
(Quarts)
Amount Fed
(Quarts)
Energy
(% or Req.)
Protein
(% of Req.)
1.0 3.5 4.0 56 52
1.6 5.25 6.0 85 78
2.1 7.0 8.0 113 103
2.6 8.75 10.0 141 128
¹Calculations are based on equations from the 2001 Dairy NRC. It is assumed that the milk replacer contains milk-based proteins and has a lactose content of 45% (DM-basis).
²Powder: water ratio presented ensures a mixed solids content of 12.5%

Obviously, increasing the feeding rate or nutrient density of a milk replacer is a significant economic investment, so it is important to weigh the cost vs. potential return. Benefits from increasing the amount of nutrition consumed from milk replacer could include: an earlier age at weaning (fewer days on milk = saved labor and milk replacer); reduced calf-hood illness (fewer treatments = saved labor and treatment costs); or an increase in first lactation milk production (increased revenue from higher sustained levels of production).

Although it may seem daunting to purchase a 27:20 milk replacer compared with a 20:20 replacer, also consider that in the example above, the same calf would need to consume more than half a pound less milk replacer powder per day with the 27:20 replacer to achieve results similar those possible with a 20:20 replacer.

Ensure Accurate Measurements

The ideal solids content of reconstituted milk replacer is around 12.5%. Feeding milk replacer with a solids content greater than 13.5% can be problematic for calves and increases risk for scours and poor digestion. The only way to ensure a consistent and accurate milk meal at every feeding is to measure the amount of water and milk replacer powder. This means using a scale to weigh the powder and a volumetric (liquid) measuring device to measure the amount of water. The plastic cups that comes in the bag of milk replacer is generally NOT a consistently accurate means of measuring the amount of powder at each feeding. Remember, calves (and cows) thrive on consistency.

Take Home

Calf inside a calf hutch

The historical mindset was to feed as little milk replacer or milk as possible in order to encourage solid feed intake. However, this approach can significantly impair pre-weaning growth and causes producers to miss out on capturing the benefits of the inherently high feed efficiency of calves during this period.

Although ensuring adequate intake of high quality colostrum during the first few hours of life is arguably the most critical step in the calf program, nutrition before weaning can also have significant long-term effects on performance. Therefore, avoid overlooking this important aspect of the your replacement program.

This article appears on the September 22, 2021, Volume 2, Issue 3 of the Maryland Milk Moo's newsletter.

Maryland Milk Moo's, September 22, 2021, Vol.2, Issue 3

Maryland Milk Moos is a quarterly newsletter published by the University of Maryland Extension that focuses on dairy topics related to Nutrition and Production, Herd Management, and Forage Production. To subscribe to this newsletter, click the button below to enter your contact information.

Subscribe